Floodwater soaks building materials and contents, and it's usually contaminated with sewage, chemicals and debris. Mold can begin to grow within a day or two. Federal guidance from EPA, CDC and FEMA follows the same sequence: safety, drying, removal, cleaning.
1. Safety first
- Electricity: don't enter standing water or turn on power until an electrician confirms it's safe.
- Structural damage: watch for sagging ceilings, floors and walls.
- Carbon monoxide: run generators, pressure washers and other gasoline equipment outdoors, at least 20 feet from the building, never exhausting into doors or windows.
- Who should stay away: people with asthma or other breathing problems, weakened immune systems, and children should not take part in mold cleanup.
2. Protect yourself
At a minimum, wear an N-95 respirator, goggles and protective gloves. Add rubber boots and coveralls for floodwater and sewage. Wash up and change clothes before leaving the work area.
3. Dry fast: the 24 to 48 hour rule
EPA says to dry the building and contents within 24 to 48 hours. If you couldn't, assume mold is growing. Open the building, run dehumidifiers, and use fans only when electricity is safe and before mold has started to grow, because fans can spread spores once it has.
4. Throw away what can't be cleaned and dried
The general rule: discard anything porous that got wet and can't be thoroughly cleaned and dried within 24 to 48 hours. After floodwater, that usually includes:
- Carpet and pad, upholstered furniture and mattresses.
- Drywall and insulation up to and above the water line, to where materials are dry and undamaged.
- Ceiling tiles, paper products and cardboard.
- Food, medicines and cosmetics that touched floodwater.
Photograph everything for insurance before disposal.
5. Clean hard surfaces
- Scrub hard surfaces with detergent and water, then dry. Floodwater calls for disinfection of surfaces it touched; follow product labels.
- Never mix bleach with ammonia or other cleaners.
- Don't paint or caulk over mold; clean and dry first.
- Clean and dry wall cavities, framing and subfloors before rebuilding.
6. HVAC
Don't run an HVAC system that was flooded or may be contaminated. Have it inspected and cleaned by a qualified contractor; EPA says wet or moldy duct insulation can't be effectively cleaned and should be replaced. See mold in air ducts.
7. Know when you're done
Federal guidance: cleanup is complete when visible mold and moldy odors are gone, materials are dry, and there's no sign of regrowth on follow-up. Sampling is usually not recommended; a careful inspection, including the HVAC system, is more useful.
For property managers
- Communicate with residents about safety, relocation and timelines.
- Use qualified contractors for large losses, contaminated water and HVAC work.
- Document moisture readings, removals and completion for every unit. See the water intrusion checklist.
Sources and official references
Last reviewed: October 25, 2026 · Free general education based on EPA and CDC mold guidance and OSHA worker-safety principles. It is not an EPA or OSHA certification or a state mold license, not medical or legal advice, and it does not issue a certificate. Nothing you enter on this page is saved or sent.
